Specifications for Sheet, Zinc-Coated, (Galvanized) WindBrace Steel Roll Forming Machine by the Hot-Dip Process.

• Galvanized G60 to ASTM A653
• Mechanical properties to ASTM A653
• Panel Design thickness of 5mm
• Begin by establishing a run-line using the bracing as a guide for a straight edge.
• Make a single saw kerf cut at least 1/2” deep along the run-line.
• Insert the bracing web into the kerf and secure it by nailing it to the studs.
• For walls pre-framed on the floor, position the bracing web into the kerf and drive a nail into the top plate.
• Lift the wall into position and ensure it is plumb before securing the top plate, bottom plate, and studs according to the nailing schedule.

Windbrace is designed to offer resistance against racking during the construction process and also allows for exterior insulation. It has a flat surface which makes it easy to use both inside and outside.

Main machine parameters:

Voltage: As customer request

Material thickness: 1.5-3.0 mm, yield strength≤G345Mpa

Processing material: PPGI,GI, Q345, HR steel etc.

Working speed: 0-12 m/minute

Profile drawing:

WindBrace Steel Roll Forming Machine working flow:

The Technical Specifications Of The Wind Brace Steel Roll Forming Machine：

Wind Brace Steel Roll Forming Machine
1.Material of coil	Material Thickness	1.5-3.0 mm
2.Forming system	Rolling Speed	0-12m/min( without the cutting time)
3.Main body	Roller Stations	About 20 stations
	Roller Material	Cr15
	Maim Motor Power	15 kw
	Hydraulic cutting Power	2.2 kw
	Leveling rollers	4 up + 5 down
	Material Of Cutting	CR12 with quench treatment
	yield strength	≤G345Mpa
	Tolerance	+-1.5mm
4.Cutter	Cutting way	Stop cutting
5.Voltage	Electric Source	Also can satisfy Customer’s require
6.Control system	Control System	PLC Delta
	Inverter	Yaskawa
	Weight	About 2.5 tons
	Table size	3.0 x 1.0 x 0.9m
	MOTOR	Under the frame of the machine

More pictures of the machine：